Computerized needle stitching

Update:08 Dec 2018
Summary:

Stitch: (Principle: slanting in and out) 1. After the e […]

Stitch:

(Principle: slanting in and out)

1. After the embroidery needle is worn out at 1 o'clock, use a needle tip to put a bead from the dish.

2. Pass the needle that is wearing the beads from 2 (diagonal) and then out from 3 o'clock. This will embroider a bead. (Note: The step from 2 to 3 is to directly thread the needle, completely on the front side of the embroidered cloth. Do not split into two steps, first penetrate the needle completely into the 2 and then put the needle from the back from the 3. This compares Expensive.)

3. At this time, the position of the needle is exactly the starting point of the second bead. According to the above method, the second bead is used.

4. After embroidering a row, take the needle from the back to the second row and take it out. In order to ensure that the inclination direction of each row of beads is the same, the second row of embroidery is reversed, because one row is embroidered from left to right, and the next row is embroidered from right to left. That is to say, if the needles of 1, 3, 5, and row are embroidered from top to bottom, then the 2, 4, and 6 rows will be embroidered from bottom to top.

www.cnjinlong.net

PREV :       It is the last article